1.  Remove reset button extender from small plastic bag and slide over Vlocity reset button.

*TIP- Due to slight variations in manufacturing tolerances, the Vlocity reset button may not be centered in the hole provided in the left half shell resulting in the button not moving freely. If so, enlarge the hole with a 13/64” drill bit.

2.  Install Vlocity collar adapters. The adapters may be installed on the feed neck or may be installed in each shell half independently. Collar tabs should be centered at the front and pointed upward.

3.      Insert the Vlocity loader assembly into the left half shell, rear first, taking care   

 not to bend or break the reset button.

4.  Slide the right side shell into place making sure that the battery leads are routed through the provided slot and do not get pinched.

5.  Make sure that the battery cover screw retention nut is in place and replace the housing screws.

* TIP- Attach batteries and test loader functions before installing final screws.

6.  Insert the lid-retaining latch into the slot at the rear of the filler opening. It will snap/lock into place.

7.      Snap the top lid assembly and/or the Tournament Adapter into place starting with the front lip first then snapping the rear into place.

8.      Attach the battery cover with the shortest of the four screws.